Charging The Battery - Ericsson DT570 User Manual

BusinessPhone - Portable Telephone DT570

Charging the battery

When the battery requires charging, you will hear a warning
sound and the display will indicate it. Regarding charge time, see
section "Battery performance".
Note: You can charge the battery any time. There is no
need to wait until the battery is completely discharged.
Connect the portable to the charger as shown in the figure
below
The charging process will start automatically, indicated by a green
light on the charger. If the phone is turned off during charging,
the LED turns red, and the battery icon flashes sequentially.
Leave the portable connected to the charger until the
battery is fully charged.
It takes approximately one hour to fully charge the standard
battery, see "Battery performance". During charging, you can
use the portable as usual. When charging process is complete,
the indicator light on top of the portable turns green, and the
battery icon is completely filled.
Disconnect the charger.
Notes:
Do not connect your phone to the charger without a battery.
If the standby time for your DT570 becomes too low, you
should replace the battery.
Only use the charger that is delivered with your portable
to charge the battery.
Installation
87