Charging Your Battery; Your Charger - Ericsson R300D User Manual

Charging Your Battery

Your Charger

Your phone was packaged with either
a rapid or travel charger. It is important
that you fully charge your battery before
you use your phone. Both chargers supply
power to charge your battery while the
battery is attached to your phone. If your
phone is On, it can receive calls while using
either charger.
Note! attach the charger to a phone
I@W@S
that does not have a battery installed.
1 If you have a rapid charger, plug the
charger into a standard wall electrical
outlet. If you have a travel charger, connect the appropriate AC
power cord and phone charging cord to the travel charger.
2 Hold the phone with the display and keypad facing up.
3 Hold the small plug on the charger cord so the lightning bolt
symbol ( ) is up.
4 Align the small plug on the charger cord with the connector on
the bottom of your phone. The connector on the phone is above
the lightning bolt symbol ( ).
5 Press the plug into the connector until the plug "snaps" into place.
The icon is alternated with the
powered on and the phone is charging.
Getting Started
rapid
rapid
Note!
travel
travel
Note!
icon when the phone is
Do not twist while inserting or removing the small plug on the
charger cord!
6 Continue charging the phone until the battery is fully charged.
7 To disconnect the charger, lift the plug connected to the phone
upwards and pull it out.
Charge-Only Mode
If your phone is off, attaching the charger will cause the phone to
activate in charge-only mode. When this mode is activated, the
message Charging Only appears in the display. Your phone is
now fast (rapid) charging the battery. When your phone is fully
charged, Battery Charged appears in the display.
You cannot make or receive calls when your phone is in charge-
only mode.
Slow (Trickle) Charging a Deeply Discharged
Battery
The battery could become deeply discharged (for example, when the
battery is stored for a long period). As a result, the phone may not
12