Table of Contents
Advertisement
VSM PRESET SETTING
Measuring
Item
instrument
Setting of
Remote
VSM PRESET
control unit
V/C (VIDEO/CHROMA) CIRCUIT ADJUSTMENT
● ● ● ● The setting (adjustment) using the REMOTE CONTROL UNIT is made on the basis of the initial setting values.
● ● ● ● The setting values which adjust the screen to the optimum condition can be different from the initial setting values.
Measuring
Item
instrument
Ad justment
Signal
of WHITE
gener ator
BALANCE
(High-Light)
Remote
control unit
Ad justment
Remote
of
control unit
SUB BRIGHT
Ad justment
Remote
of
control unit
SUB
CONTRAST
Test point
Ad justment part
1. CONT.
2. BRIGHT
3. SHARP
4. COLOUR
5. HUE
6. R. GAIN
7. G. GAIN
8. B. GAIN
Test point
Ad justment part
1. R. GAIN
2. G. GAIN
4.BRIGHT
5.CONTRAST
No. 51955
Description
1. Press the MENU (OK) key and s elect COOL mode with the
remote control unit.
2. Select 5.VSM PRESET from the SERVICE MENU.
3. Adjust the FUNCTION ▲ /▼ and
values of 1.CONT ～ 8.B GAIN to the initial setting values as
shown in the before table.
4. Press the MENU key and memoriz e the s et value.
5. Respectively select the VSM PRESET mode for NORMAL and
WARM, and make similar adjustment as in 3 above.
6. Press the MENU (OK) key and memorize the set value.
★ Refer to OPERATING INSTRUCTIONS for the PICTURE
MODE.
Description
" Set the PICTURE MODE to NORMAL.
1. Receive a black and white signal (colour off).
2. Select 2. V/C from the SERVICE MENU.
3. Modify 1.R.GAIN and 2.G.GAIN value to set the white balance
( high light ).
4. Press the MENU (OK) key and memorize the set value.
5. Change the contrast and brightness up and down with the
remote control unit from Low–light to High–light, and chec k that
the trac king of the white balance is good.
1. Receive any broadc ast.
2. Select 2.V/C from the SERVICE MENU.
3. Select 4.BRIGHT with the FUNCTION ▲ / ▼ key.
4. Set the initial setting value with the FUNCTION
5. If the brightness is not the best with the initial setting value,
make fine adjustment until you get the bes t brightness.
6. Press the MENU (OK) key and memorize the set value.
1. Receive a PAL colour bar signal.
2. Switch the sub power SW to OFF & ON.
3. Select 2.V/C from the SERVICE MENU.
1. Select 5.CONTRAST with the FUNCTION ▲/▼ key.
5. Set the initial setting value with the FUNCTION
6. If the contrast is not the bes t with the initial setting value, make
fine adjustment until you get the best contras t.
7. Press the MENU (OK) key and memorize the set value.
AV42PD20ES
/
key to bring the set
/
key.
/
key.
29
Advertisement
Table of Contents
