Samsung ACN016NDEHA Installation Manual page 18

Setting an indoor unit address and installation option AA
Setting an indoor unit installation option (suitable for the condition of each installation location)
1. Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional power supply in the indoor unit.
2. The panel(display ) should be connected to an indoor unit to receive option.
3. Set the installation option according to the installation condition of an air conditioner.
- The default setting of an indoor unit installation option is "02000-100000-200000-300000".
- Individual control of a remote controller(SEG20) is the function that controls an indoor unit individually when there is
more than one indoor unit.
- No need to assign SEG3, 6, 9, 10, 11, 16, 21, 22, 23, 24 which are non applicable. Even though those segments are set,
they will be ignored.
- If you set the applicable segments with numbers other than the indiciated, the initial setting will be maintained.
4. Set the indoor unit option by wireless remote controller.
Option No. : 02XXXX-1XXXXX-2XXXXX-3XXXXX
Option
Indication Details Indication
Indication
and
0
Details
Option
Indication Details Indication
Indication
and
1
Details
Option
Indication Details Indication
Indication
and
2
Details
18
Details
2
Use of drain pump
Details
0 Disuse
1 Use
2 3minute
delay
Use of external Setting the output
control of external control
Details Indication Details Indication Details Indication
0 Disuse 0
1
Control
OFF
2 1
Control
3
Control
Use of external
temperature sensor
Indication Details Indication
0 Disuse
1 Use
Thermo
0 Disuse
on
Operation
1 Use
on
Use of central RPM setting
control compensation
Details
1. High ceiling mode
0 Disuse
2. High ceiling kit
3. Low noise operation
1 Use
mode
Indication Details
0
1
Details Indication Details
Mixed operation
0 control 1/Use 2 1000 Hour
Mixed operation
1 control 1/Disuse
Mixed operation
2 control 2/Use
Mixed operation
3 control 2/Disuse
master
2000
Hour