Ricoh PRO C5200S Operating Instructions Troubleshooting: Tcru/Oru page 36

3. Troubleshooting Image Quality Problems
2. Check the present value. Is it lower than 50 A ?
Yes Carry out all of the following:
(1) Increase the value by 5 A in [Image Transfer Current: FC: K].
(2) Set [Paper Transfer Current: TE: FC] to "200%".
(3) Set [Paper Transfer Current: TE Length: FC] to "30 mm".
No No further improvement is likely. Contact your service representative.
3. Print the image. Is the problem resolved?
Yes Finished!
No Repeat Steps 1 to 3. If the problem persists even though you have increased the value to
50 A, contact your service representative.
<Printing in black and white>
1. In [Advanced Settings] for the custom paper in use, select [Image Transfer Current: BW].
2. Check the present value. Is it lower than 50 A?
Yes Carry out all of the following:
(1) Increase the value by 5 A in [Image Transfer Current: BW].
(2) Set [Paper Transfer Current: TE: BW] to "200%".
(3) Set [Paper Transfer Current: TE Length: BW] to "30 mm".
No No further improvement is likely. Contact your service representative.
3. Print the image. Is the problem resolved?
Yes Finished!
No Repeat Steps 1 to 3. If the problem persists even though you have increased the value to
50 A, contact your service representative.
34