Connecting The Power Cable; Connecting Your Computer To The I38Hg; Connecting Via Ethernet Ports - 2Wire i38HG User Manual

iNID User Guide

Connecting the Power Cable

Connect one end of the power supply cable to the
1.
Connect the other end of power supply cable to a 3-prong AC electrical outlet.
2.
Note:
For safety reasons, do not modify electrical outlets that do not have a
3-prong plug with a 3-prong adapter.
Observe the
3. POWER
Note:
Refer to the
green.

Connecting Your Computer to the i38HG

There are two ways to connect your computer to the i38HG: via Ethernet or wireless. With either connection,
the first computer you connect to the network is used to configure the i38HG for proper operation.

Connecting via Ethernet Ports

You can directly connect up to four computers to the i38HG using the Ethernet connection. Connect one
end of the Ethernet cable (yellow) to any available ETHERNET port (yellow) on the i38HG and the other end
to the computer's Ethernet port
You are now ready to start your system (refer to the
Note:
Your i38HG is shipped with an 6-foot Ethernet cable. Use a CAT5 cable
if you need additional or longer Ethernet cable.
Computer
Ethernet Connection
Figure 6: Ethernet Connection
12
indicator; it flashes red once, followed by flashing green, then remains solid green.
Finding Solutions
(Figure 6).
AC Power
i38HG
port of your i38HG
POWER
section if the indicator does not stay
Setting up System Information
(Figure 4).
section).