Powering On The Mc55 - Motorola MC55 User Manual

To accomplish this, for small periods of time, the MC55 or accessory alternately enables and disables battery
charging to keep the battery at acceptable temperatures. The MC55 or accessory indicates when charging is
disabled due to abnormal temperatures via its LED. See

Powering On the MC55

Press the Power button to turn on the MC55. If the MC55 does not power on perform a warm boot. See
the MC55 on page 2-13.
When turning the MC55 on for the first time, the splash screen displays for about a minute as the MC55 initializes
its flash file system, then the calibration window appears. Note that these windows also appear upon cold boot.
NOTE When the MC55 powers up after inserting a battery for the first time, the device boots and powers on
automatically.
Calibrating the Screen
To calibrate the screen so the cursor on the touch screen aligns with the tip of the stylus:
Remove the stylus from its holder on the back of the MC55.
1.
Carefully press and briefly hold the tip of stylus on the center of each target that appears on the screen.
2.
Repeat as the target moves around the screen, then tap the screen to continue.
3.
Checking Battery Status
To check the charge status of the main battery or backup battery in the MC55, tap
icon to display the
Power
To save battery power, tap the
window.
Power
tab and set the MC55 to turn off after a specified number of minutes.
Advanced
Table 1-2.
Start
Getting Started 1 - 9
Resetting
> > tab >
Settings System