Getting To Know Your Device - Zte z Quick Manual

Humidity
Notes:
microSD is a trademark of SD Card Association.
The device's standby and working time are only for your reference, and based on ideal working
environment.

Getting to Know Your Device

The following figure shows the appearance of the device. It is only for your reference. The actual device
may be different.
Interface and Buttons
1.Power Hold the Power button to switch on/off the device.
 Press to connect to or disconnect from the Internet.
2. Internet
 Hold for about five seconds to change between manual and automatic
3.WPS This button is used to start Wi-Fi Protected Setup authentication process and
enable/disable the Wi-Fi function.
 Hold it for about five seconds to activate the WPS process.
 Hold it for about two seconds to enable/disable Wi-Fi function.
4. LED Screen It is to indicate the signal type, signal strength, battery, Wi-Fi, etc.
 Charge your device.
5.Charger/USB
port
 Connect the client to your device via USB cable.
Notes:
Press WPS and Power buttons simultaneously, and hold on about three seconds until all LEDs are off,
•
then release the buttons, the device will restart automatically and restore to the factory default settings.
Please use the original external antenna if necessary.
•
2 Confidential and Proprietary Information of ZTE CORPORATION
5%~ 95%
connection.