Others - Leetro MPC6535 User Manual

4.2 Run Lasercut53.exe for Settings:
A. Controller Type
B. Laser Power
C. Limit Datum Active Level
D. Pulse Equivalency
E. Working Table Size
F. Homing Direction
G. The Jerk is set as TEN times of the Acceleration
H. The turn acceleration is set as TWO times of acceleration
I. Tune for better performance
(for details, go to see LaserCut manual)
4.3 Download configure files and reset the control system
4.4 Input working files, edit the diagram, make the settings, download the file into controller
4.5 Start working.

5. Others

1. Must be careful with the positive and negative ends of MPC6535' s power supply
2. Must turn the power off when disconnect the cable between control PAD and the board.
3. Make sure the metal case of MPC6535 wires to GROUND firmly
4. Setting pulse mode in the parameter for controller signal receiving
5. We recommend user take " LAS-"port for firing laser
6. Make sure the Dongle Serial Number (SN) matches the board SN
- 8 -