Omnia Volt Quick Start Installation Manual page 3

Fm version

Hide thumbs Also See for Volt:

audio connectionS

a. For balanced line-level analog, connect XLR audio cables to the ANALOG LEFT OUT and RIGHT OUT

jacks (E).

b. For Digital audio, connect the male XLR "Studio Hub" adaptor cable provided to the RJ-45 AES OUT jack (F).

c. For an existing Axia or Livewire system, the single Livewire Ethernet connection made in the input setup

is all that is needed for audio I/O (D).

d. If using the built-in FM stereo generator, connect one of the composite MPX BNC outputs (G) to your FM

exciter or composite STL.

2. Connect the Omnia VOLT to AC Mains (H) using

the AC power cable supplied. Make sure the power

source is properly grounded. There is no power

switch.

3. Once power is supplied, a red power indicator (I)

next to the LCD (J) will light up. The LCD will remain

dark for about 25 seconds, then will display "Omnia

VOLT" as the startup sequence progresses. A few

seconds later, the main menu will be displayed.

continue to audio conFiGuration

The initial set-up of your Omnia VOLT is complete and ready to be configured.

Continue to the "Audio Configuration" instructions.

(cont.)

AUDIO OUTPUT - All outputs are active simultaneously.

Table of Contents