Bosch WTVC SERIES Repair Instruction page 22

6) Remove burner screws, including screws holding burner
bracket to base and combustion chamber and screws holding
burner to bracket.
5.1.13 Motor, belt tensioner and broken belt switch
All three are mounted on motor cradle, located behind air duct
(viewing rear of dryer), and can be accessed from front or rear of
dryer. Motor must be disconnected from fan (5.1.17) and belt from
motor pulley before motor can be removed.
motor cradle with motor, belt tensioner and broken belt switch can be
unscrewed and slid out from dryer. To remove motor from cradle,
remove two spring clips and lift up from cradle.
Belt tensioner
702_58300000143767_ara_en_a
Once disconnected,
Motor
5.1.14 Front panel
1) Remove fascia panel (5.1.2). If necessary for access, remove top
panel (5.1.1).
2) Remove door (5.1.7) and door hinge (5.1.9.8).
3) Remove lint screen and door seal.
4) Remove toe kick panel (5.1.6).
5) Remove T-20 Torx screws from top / bottom of panel and around
door, then lift panel up (from four plastic mounting tabs).
6) Remove door switch from panel by disconnecting wire harness,
squeezing two tabs on switch and pushing switch through front of
panel.
7) To remove belt tension (so drum doesn't shift when front bearing
shield is removed), remove rear panel (5.1.10) and disconnect belt
(from motor pulley).
Tab
Page 22 of 33