Conn. Settings - Nokia N91 User Manual

Call waiting (network service)—If you have activated call
waiting, the network notifies you of a new incoming call
while you have a call in progress. Select
request the network to activate call waiting,
request the network to deactivate call waiting, or
status to check if the function is active or not.
Reject call with SMS—Select
to a caller informing why you could not answer the call.
See "Answer or reject a
Message text—Write a text to be sent in a text message
when you reject a call.
Automatic redial—Select On, and your device makes a
maximum of ten attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialling,
press .
Summary after call—Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
Speed dialling—Select On, and the numbers assigned to
the speed dialing keys (
and holding the key. See also
p. 26.
Anykey answer—Select On, and you can answer an
incoming call by briefly pressing any key under the slide
cover.
92
Activate to
Cancel
Yes to send a text message
call", p. 27.
- ) can be dialed by pressing
"Speed dial a phone number",
Copyright © 2006 Nokia. All rights reserved.
Line in use (network service)—This setting is shown only if
the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
to for making calls and sending text messages. Calls on both
Check lines can be answered irrespective of the selected line.
If you select Line 2
network service, you will not be able to make calls. When
line 2 is selected,
Tip! To switch between the phone lines, press and
hold
Line change (network service)—To prevent line selection,
select Line change
card. To change this setting, you need the PIN2 code.

Conn. settings

Data connections and access points
Your device supports packet data connections (
GPRS in the GSM network.
Glossary: General packet radio service (GPRS) uses
packet data technology where information is sent in
short packets of data over the mobile network.
To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
• MMS access point to send and receive multimedia
messages
and have not subscribed to this
is shown in the standby mode.
in the standby mode.
> Disable if supported by your SIM
), such as