Table of Contents
Advertisement
Fig.16
Power wiring
NOTE) 2. 3.
Clamp
(accessory (4))
<Precautions When Doing Wiring Work>
NOTE)
1. All wiring going into the control box should be passed through a plastic push.
2. Please fix the clamps at the internal and external sides (two at each side) of the control box.
3. Fix the power wires and the ground wires as illustrated.
4. Fix the branch wires and the remote controller wires as illustrated.
5. The specification for the fuses on the indoor unit PCB: 250V 5A (F1U)
6. If using shield wire for transmission wiring, ground the shield of the shield wire to "
troller cord grounding terminal inside the control box.
14
Ground wire
NOTE) 2. 3.
Remote controller wiring
Branch wire
NOTE) 2. 4.
NOTE) 2. 4.
NOTE) 1.
Noiseless earth
* Do not clamp remote controller cords
together with wires connecting the units.
Doing so may cause malfunction.
Ground the shield part of
shielded wire.
(Refer to NOTE 6)
Shield part
Fig.15
", at the grounding screw of the remote con-
Grounding terminal for
the remote controller
* Remote controller cord
(Shield wire NOTE 6)
Earth
screw
C-cup washer
English
Advertisement
Table of Contents
