Redline Access Node-50 User Manual page 9

AN-50 User Manual
Reset – A paper clip, or similar object, can be used to reset the system by
depressing the "Reset" button recessed in the front panel. The reset button is used
to reactivate the terminal in the event that it is functioning improperly or is in a
state of suspension. Depressing the reset button for more than 5 seconds will
restore the unit's operating system back to the last successfully loaded software
revision.
Pwr – The "Pwr LED" lights solid and green when the AC power is properly
applied to the terminal. In the event the power fails or the cord is disconnected,
the "Pwr LED" light will not illuminate.
Fault – The "Fault LED" will light solid and red when a serious fault is detected
within the system. If this occurs, depress the "Reset" button for more than 5
seconds to try to restore the terminal. If the problem persists, then contact the
Redline support line.
B) Wireless
The wireless portion of the front display contains two LEDs, one for the Link and
the other for Signal, as shown below.
Link – The "Link" LED lights solid and green when the communication link to
the remote terminal is functioning properly at the specified data rate (refer to the
Configuration section for details regarding data rate). The LED will flash green
when the system operates at a lower data rate.
When the link is compromised, the LED stops illuminating.
9/52
Redline Communications .....solving the first mile challenge.