Redline Access Node-50 User Manual page 10

AN-50 User Manual
Signal – The "Signal" LED flashes in amber when signal errors are detected due
to degradation in the communication link.
C) Ethernet
The Ethernet portion of the front panel display comprises four main LEDs,
including Link, 100, FD and Col, as shown below.
Link – The "Link" illuminates solid and green when the Local Arean Network
(LAN) connection to the remote terminal is functioning properly.
100 – The "100" LED lights solid and green when the Ethernet port is operating
at 100 Mb/s. The LED will not illuminate if the port is operating in 10 Mb/s
mode. Note the Ethernet port automatically selects the speed through auto-
negotiation with either the host computer/server or router/switch.
FD – The "FD" LED illuminates solid and green when the LAN connection is
operating in Full Duplex mode. The LED will not illuminate if the system is
operating in Half Duplex mode. The system automatically selects the duplex
mode through auto-negotiation with the host computer or switch.
Col – The "Col" LED flashes in amber when collisions occur in the LAN traffic.
D) LAN Interface
The LAN interface is an Ethernet port, also known as a 10BaseT port, which is
used to connect the AN-50 to either the core network or to a host computer. A
router or switch will likely be used to complete the connection to the core
network, as shown in the next figure.
10/52
Redline Communications .....solving the first mile challenge.