Table of Contents
Advertisement
AN-50 User Manual
6.
System Configuration and Operation
This section describes the procedures for configuring and operating the AN-50
terminal. All communication to the AN-50 is achieved over the Ethernet port,
using Hypertext transfer protocol (HTTP). This offers the advantage of allowing
the operator to access and control the AN-50 remotely from any geographical
location, providing the operator at the remote site has access to the Internet. It is
important to note, for the initial set-up, the operator must connect the host
computer locally to the AN-50 as shown in Figure 8.
Although the procedures to configure the AN-50 are relatively straightforward,
some familiarity with basic computer networks and administration would be
helpful.
6.1.
Home Page Screen
The first step is to log onto the AN-50 home page from a web browser, such as
Microsoft Internet Explorer, by typing in the system's IP address. The system's
default address (from the manufacturer) is 192.168.25.2, which will take you to
the screen shown in Figure 11.
Figure 11 AN-50 Home Page.
If the screen does not match the illustration in the figure, then check for possible
entry errors and retype if necessary, otherwise refer to the diagnostics section,
Section 7, for further assistance.
20/52
Redline Communications
.....solving the first mile challenge.
Advertisement
Table of Contents
