Figure 14 Bridge Configuration Screen - Redline Access Node-50 User Manual

AN-50 User Manual

Figure 14 Bridge configuration screen.

IP address: This field is used to provide an IP address for the local AN-50
terminal. The default address from the factory is 192.168.25.2. For the
initial set-up, the terminal should not be connected to the Internet network,
i.e. the host computer should be connected directly to the terminal
Ethernet port, to avoid address conflicts with other devices in a public
network. Once the IP address has been set, the terminal can be connected
to the core network, where it can receive either static or dynamic
addressing (DHCP) in future configuration updates.
Netmask: This field is used by the operator to set the desired network
mask. The netmask value is typically set to "255.255.255.0 (Class C
subnet), which prevents certain local devices from going out into the
wireless network.
Gateway: This field is used to specify the IP address of the gateway with
which the AN-50 is communicating through the core network.
25/52
Redline Communications .....solving the first mile challenge.