Multi-position hinge
@
LED bezel
;
LED
=
Retractable hook
%
Automatic switch
&
3.2 Intended use
The product described is a cordless lamp. It is intended for use as illumination on
jobsites. Use the product in a dry environment only.
SL 2-A12
Use only Hilti Li-ion batteries from the B 12 series with this product.
▶ Use only the Hilti battery chargers of the C 4/36 series with the CA-B12 charging
adapter, or battery chargers of the C 4/12-50 series for charging these batteries.
SL 2-A22
Use only Hilti Liion batteries of the B 22 series with this product.
▶ Use only the Hilti battery chargers of the C4/36 series for charging these batteries.
3.3 Charge state indicator
Lightly press (no more than until resistance is perceptible) either of the battery release
buttons to check the charge state of the Liion battery.
Status
4 LEDs light up.
3 LEDs light up.
2 LEDs light up.
1 LED lights up.
1 LED flashes.
Note
If the LEDs of the charge state indicator flash, follow the instructions in the
'Troubleshooting' section.
3.4 3-mode switch
Use the 3-mode switch to set the brightness.
Status
Press once
Press twice
Press three times
3.5 Items supplied
Cordless lamp, operating instructions.
Other system products approved for use with this product can be found at your local
Hilti Center or online at: www.hilti.com
Printed: 21.04.2017 | Doc-Nr: PUB / 5346584 / 000 / 00
3-mode switch
(
Grip
)
Battery
+
Battery release button
§
Meaning
• Charge state: 75 % to 100 %
• Charge state: 50 % to 75 %
• Charge state: 25 % to 50 %
• Charge state: 10 % to 25 %
• Charge state: < 10 %
Meaning
• The lamp lights with maximum bright-
ness.
• The lamp lights with medium bright-
ness.
• The lamp is off.
English
5