Connecting The Circuit Board - Fleck 7000SXT Service Manual

After the circuit board is installed:
1. Connect the motor wires (A) to the motor connector (A1) on board.
2. Connect the transformer cable (B) to the transformer connector (B1) on board.
3. Connect the meter cable (C) to the meter cable connector (C1) on board.
4. Connect the meter cable sensor end to the opening on the valve body.
5. Thread meter cable (D1) and power wire (D2) along path shown in above illustration.
1
A
A1

Connecting the Circuit Board

B
B1
C1
2
3
C
4
41033_REVB
Page 35