Diagnostic Programming Mode - Fleck 7000SXT Service Manual

Abbreviation
FR Flow Rate
PF Peak Flow Rate
HR Hours in Service
VU Volume Used
RC Reserve Capacity
SV Software Version
NOTES:
Some items may not be shown depending on timer configuration.
The timer will exit Diagnostic Mode after 60 seconds if no buttons are pressed.
Press the Extra Cycle button to exit Diagnostic Mode at any time.
Diagnostic Programming Mode Steps
1. Press the Up and Extra Cycle buttons for five seconds while in service.
2. Use this display to view the current Flow Rate. This option setting is identified by "FR" in the upper left hand
corner of the screen.
3. Press the Up button. Use this display to view the Peak Flow Rate since the last regeneration cycle. This
option setting is identified by "PF" in the upper left hand corner of the screen.
4. Press the Up button. Use this display to view the Hours in Service since the last regeneration cycle. This
option setting is identified by "HR" in the upper left hand corner of the screen.
5. Press the Up button. Use this display to view the Volume Used since the last regeneration cycle. This option
setting is identified by "VU" in the upper left hand corner of the screen.
Diagnostic Programming Mode Options
Parameter
Displays the current outlet flow rate
Displays the highest flow rate measured since the last regeneration
Displays the total hours that the unit has been in service
Displays the total volume of water treated by the unit
Displays the system's reserve capacity calculated from the system
capacity, feedwater hardness, and safety factor
Displays the software version installed on the controller

Diagnostic Programming Mode

Description
Page 21