User Programming Mode - Fleck 7000SXT Service Manual

Abbreviation
DO
RT
H
RC
CD
NOTES:
Some items may not be shown depending on timer configuration.
The timer will discard any changes and exit User Mode if any button is not pressed for sixty seconds.
User Programming Mode Steps
1. Press the Up and Down buttons for five seconds while in service, and the time of day is NOT set to 12:01 PM.
2. Use this display to adjust the Day Override. This option setting is identified by "DO" in the upper left hand
corner of the screen.
3. Press the Extra Cycle button. Use this display to adjust the Regeneration Time. This option setting is identified
by "RT" in the upper left hand corner of the screen.
4. Press the Extra Cycle button. Use this display to adjust the Feed Water Hardness. This option setting is
identified by "H" in the upper left hand corner of the screen.
Range: 4-199 hardness
User Programming Mode Options
Parameter
Day Override
Regeneration Time
Feed Water Hardness
Reserve Capacity
Current Day

User Programming Mode

The timer's day override setting
The time of day that the system
will regenerate (meter delayed,
timeclock, and day-of-week
systems)
The hardness of the inlet water -
used to calculate system capacity
for metered systems
The fixed reserve capacity
The current day of week
Description
Page 19