Settings - AEG L9FEA966C User Manual

36 www.aeg.com
If
temperature and level are
not high and it is still
possible to open the door
and add clothes.
While a programme or the delay start
operates, the appliance door is locked.
1. Touch the Start/Pause button .
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
necessary, add or remove the items.
3. Close the door and touch the Start/
Pause button.
The programme or the delay start
continues.
13.13 End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active).
The display tells that the cycle is finished
and shows 0h00min.
The Start/Pause button goes off.
The door unlocks and the indicator
goes off.
1. Press the On/Off button to
deactivate the appliance.
After five minutes after the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
shows the end of the last
selected programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.

14. SETTINGS

14.1 Introduction
1. In the programme summary screen,
just tap on the screen to return to the
programme list screen.
2. Scroll the list up or down to find
Settings.
is on: the water
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
13.14 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the
water of the last rinse, the programme is
completed, but:
• The display shows 0 min and the
Start/Pause button starts flashing.
• The drum still turns at regular intervals
to prevent the creases in the laundry.
• The indicator
door stays locked.
• You must drain the water to open the
door:
1. Touch the Start/Pause button:
• If you have set
drains the water and spins.
• If you have set
only drains the water.
2. If necessary, change the spin speed
proposed by the appliance: touch
the Start/Pause button to pause the
programme; tap on
the Spin Speed bar.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off button for a few
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
is still on and the
, the appliance
, the appliance
and then on