Table of Contents
Advertisement
Installation Instructions
Starting Up a Lockable Code Keypad
(or changing user codes)
7
8
9
4
5
6
1
2
3
+
-
0
The user code for the NZ 300 LSN and "integrated" SmartKey is described in de-
!
tail in the NzPara online help under "User Codes" (different default setting).
Define user code or change user code
(when the system is disarmed) as follows:
1. Press the "+" and "-" keys simultaneously for 3 seconds.
The reader's buzzer will sound for 1 second and the red and green LEDs will flash.
2. Press and hold the key button and hold the SmartKey up to the reader for > 1 second. This
will assign the SmartKey to the corresponding user number (ID). Users without a key must
enter their user number (ID).
The buzzer will sound for 1 second and the LEDs will be deactivated.
3. When starting up for the first time, enter "000000" and confirm your input with the " - " key
- or,
If you want to change the user code, enter the "old user code" and confirm your input
with the " - " key.
The reader's buzzer will sound for 1 second and the green LED will light up.
4. Enter the new user code and confirm your input with the
" - " key.
The reader's buzzer will sound for 1 second, the green LED will light up and the red LED
will flash.
5. Enter the new user code once again and confirm your input with the " - " key.
The reader's buzzer will sound for 3 seconds, and the green and red LEDs will light up for
3 seconds and then go out.
The new user code is now valid.
Define your user code during the first start-up. You can change your
user code at a later date. Both operational procedures are identical.
User codes can only be changed if the soldering bridge LF1/LF2
on the keyboard circuit board is closed (see code keypad instal-
!
lation instructions).
Use this key to verify entries.
Use this key to abort an operation.
24
.
Advertisement
Table of Contents
