Automatic Picture Quality Adjustment Function (For Hd15/Pc Signal Only); Making Further Automatic Adjustments To The Picture Quality For The Current Input Signal (Auto Adjust) (For Hd15/Pc Signal Only); Adjust The Picture's Sharpness And Position Manually (Pitch/Phase/H Center/V Center) (For Hd15/Pc Signal Only) - Sony SDM-H246W Operating Instructions Manual

x Automatic picture quality adjustment
function (for HD15/PC signal only)
When the display receives an input signal, it automatically
adjusts the picture's position and sharpness (phase/pitch),
and ensures that a clear picture appears on the screen
(page 23).
If the automatic picture quality adjustment function of this
display seems to not completely adjust the picture
You can make further automatic adjustment of the picture quality for the
current input signal. (See "Auto Adjust" below.)
If you still need to make further adjustments to the picture
quality
You can manually adjust the picture's sharpness (phase/pitch) and
position (horizontal/vertical position).
These adjustments are stored in memory and automatically
recalled when the display receives a previously input and
registered input signal.
x Making further automatic adjustments to
the picture quality for the current input
signal (Auto Adjust) (for HD15/PC signal
only)
1 Press the MENU button.
The main menu appears on the screen.
2 Press the m/M buttons to select
press the OK button.
The "Screen" menu appears on the screen.
3 Press the m/M buttons to select "Auto Adjust" and
press the OK button.
The "Auto Adjust" menu appears on the screen.
4 Press the m/M buttons to select the desired mode
and press the OK button.
• On: Make the appropriate adjustments of the screen's
phase, pitch and horizontal/vertical position for the
current input signal and store them.
Note
When the monitor is turned on or the input signal is changed,
"Auto Adjust" makes the automatic adjustments,
• Off: "Auto Adjust" is not available.
Note
"Auto Adjust" works automatically when the input signal is
changed.
x Adjust the picture's sharpness and position
manually (PITCH/PHASE/H CENTER/
V CENTER) (for HD15/PC signal only)
You can adjust the picture's sharpness as follows. This
adjustment is effective when the computer is connected to the
monitor's HD15 input connector (analog RGB).
1 Set the resolution to 1920 × 1200 on the computer.
2 Load the CD-ROM.
3 Start the CD-ROM
For Windows User
When Auto run operates:
Select the area, language and model, and click DISPLAY
ADJUSTMENT TOOL (UTILITY).
4 Click "Adjust" and confirm the current resolution
(top value) and recommended resolution (bottom
value), and then click "Next".
Test pattern for PITCH appears.
5 Press the MENU button.
The main menu appears on the screen.
6 Press the m/M buttons to select
press the OK button.
The Screen menu appears on the screen.
7 Press the m/M buttons to select PITCH and press the
OK button.
The PITCH adjustment menu appears on the screen.
8 Press the m/M buttons until the vertical stripes
disappear.
Adjust so that the vertical stripes disappear.
(Screen) and
9 Press the OK button.
The main menu appears on the screen.
If horizontal stripes are observed over the entire screen, adjust
the PHASE using the following procedures.
10 Click "Next".
Test pattern for PHASE appears.
11 Press the m/M buttons to select PHASE and press
the OK button.
The PHASE adjustment menu appears on the screen.
12 Press the m/M buttons until the horizontal stripes
are at a minimum.
Adjust so that the horizontal stripes are at a minimum.
13 Press the OK button.
The main menu appears on the screen.
14 Click "Next".
Test pattern for CENTER appears.
18
(GB)
(Screen) and