Related Manuals for GENDRON Regency XL 2000
Summary of Contents for GENDRON Regency XL 2000
- Page 1 Owner’s Manual Regency XL 2000 Bariatric Manual Wheelchairs REGENCY XL2000 by GENDRON BARIATRIC REHAB LEADERSHIP 520 W Mulberry St Suite 100 * Bryan, OH 43506 U.S.A. 800/537-2521 * FAX 419/636-9261...
- Page 2 Thank you for choosing Gendron! Founded in 1872, Gendron is the oldest manufacturer of wheelchairs in the United States. Gendron occupies over 65,000 square feet of manufacturing space utilizing state-of-the-art equipment, technology and manufacturing processes. Because we control, in house, most all manufacturing, we can guarantee superior quality and unparalleled service that you can rely upon.
- Page 3 WARNING! • Gendron recommends that users not be transported in vehicles while seated in the wheelchair. We do not approve of any tie-down system for transportation of users in any moving vehicle while seated in the wheelchair. • Do not tilt the wheelchair back when occupied. This may cause serious injury to wheelchair user or assistant.
- Page 4 Correct way Footrests/Elevating Legrests- All footrests and elevating legrests are length adjustable. A simple thru-bolt provides quick and easy adjustments. Swingaway Footrests- On wheelchairs equipped with SWINGAWAY RELEASE LEVER swingaway footrests, activate the black swingaway release lever and the assembly will swing to the side. This feature permits easy entrance and exit to the chair.
- Page 5 Wheel Locks- As tires wear, adjust locks to prevent rear wheels from turning when locks are engaged. To adjust, loosen the locknuts located behind the clamp bracket. Slide clamp on rail to the proper position. Retighten the locknuts. If wheel locks become worn, replace them. Caution! ALWAYS ENGAGE WHEEL LOCKS WHEN ENTERING OR EXITING CHAIR.
- Page 6 Backrest- Backrests on all models are height adjustable by removing the two bolts and locknuts shown in the diagram to the right. Do not set the backrest to any position other than the ones illustrated here, and always use both bolts and locknuts. Rear Wheels- Rear wheel position is adjustable to change seat to floor height.
- Page 7 Anti-Tip- (optional) Anti-tip settings are shown below. These settings must match the illustrations for your wheelchair’s seat height. If seat height is changed make sure the anti-tip settings are changed. All anti-tips are the same for each seat height, only configuration defines correct anti-tip for your wheelchair’s seat height.
-
Page 8: Limited Warranty
After 60 days from date of purchase: Gendron Inc. reserves the right to not accept return goods for any reason. If accepted, the amount of credit will be at the discretion of Gendron Inc. Returned merchandise without prior authorization will not be accepted.