Stutdown Procedure - Hyundai HYSG150-2 User Manual

8.15
Roll the machine forward and back, by pushing and pulling on the control handle. To do this,
release the park brake. Relock it when the machine has been repositioned and continue
cutting.
CONTINUE WITH FINAL ROOT REMOVAL
8.16
Cut the remaining roots as described 1.166 until satisfactorily removed
SHUTTING OFF THE GRINDER
8.17
When stopping the machine after normal operation. Lower engine speed to slow, and push
the emergency switch.
8.18
Set park brake before leaving the controls
8.19
Shut off the engine by turning the ON/OFF switch to OFF.
9. SHUTDOWN PROCEDURE
9.1
In consideration of your own safety and that of others, you should always use the following
normal shutdown procedures before departing from the controls for any reason including
cleaning, servicing, transporting or inspecting the stump grinder. Never deviate from this
procedure unless so instructed in this manual or in an emergency that requires it. A rotating
cutting wheel is very dangerous. Stand at controls and ensure that the cutting wheel comes to
a complete stop before doing anything else.
9.2
Move the engine throttle to the slow position.
9.3
Push the emergency (on/off) switch to stop the engine.
9.4
Set park brake before leaving controls.
EMERGENCY SHUTDOWN PROCEDURE
9.5
Immediately push the emergency (on/off) switch to stop the engine.
9.6
Be sure to allow all moving parts to come to a complete stop.
9.7
Pull the brake lever to engage the brake.
9.8
Rectify the emergency situation and return to normal operation.
19