Antenna Output Selection - RM Italy BLA600 User Manual

7. Antenna Output Selection

The BLA600 has 3 user configurable antenna outputs. As supplied from the factory
the default antenna output is Ant:1 for all bands. Each band may be independently
configured to any one of the three outputs.
To change any particular band to different antenna output it is necessary to be in
'Standby' mode. First select the band by pressing the relevant band select key e.
Then select the required antenna output by using the '+' ` or '-' _ keys under the
LCD display to select Ant:1, Ant:2 or Ant:3 To memorise the new selection press
and hold the 'Navigate' key a for 3 seconds. The antenna output number will begin
to flash and then after 3 seconds a beep will be heard confirming the saved selection.
Each time the same band is returned to the last memorised selection will be returned.
In 'Standby' mode pressing the band key of any band will display the currently
memorised Antenna output on the LCD display.
The antenna output may also be changed temporarily without saving the selection.
This can be useful in RX/TX if testing two different antennas for the same band.
Simply use the '+' ` and '–' _ keys to change the antenna output without saving
the selection. Again this must be done in 'Standby' mode but after the change has
been made it is possible to change to 'Operate' mode and use the new selection. If a
new band is selected the non saved output will return to the default or last
memorised selection when that band is returned to.
9