RM Italy BLA600 User Manual page 22

This indicates excessive input power from the Transceiver on
the bands from 80 to 10m. The amplifier will sound 5 short error
tones and the Alarm LED
power and press the STB/OPR key
This indicates excessive input power from the Transceiver on
the bands 160 and 6m. The amplifier will sound 5 short error
tones and the Alarm LED
power and press the STB/OPR
This indicates that the transmission frequency is outside of the
predefined limits, (1.5-54MHz). The FCC version is also band
blocked, (26MHz –27.9 MHz). 5 short error tones will be
emitted and the Alarm LED
transmission frequency, press the STB/OPR
the amplifier.
This indicates that the current antenna SWR is above 2.5:1 and
the amplifier will return to Standby. The amplifier will emit 5
short error tones the Alarm LED
the error check and adjust the antenna SWR then press the STB/
d
OPR button to reset the amplifier.
This indicates excessive Drain Current. The amplifier will emit 5
short error tones and the Alarm LED
that the amplifier is not being over driven and that the antenna
SWR is within acceptable limits <2.0:1. Then press the STB/
d
OPR button to reset the amplifier.
This indicates that the drain voltage is above 70V. 5 short error
tones will be emitted and the Alarm LED
Check that the AC input voltage is correct. To reset the amplifier
d
press the STB/OPR
This indicates that the drain voltage is below 40V. 5 short error
tones will be emitted and the Alarm LED
Check that the AC input voltage is correct. To reset the amplifier
d
press the STB/OPR
This error indicates a problem with the PIN Diode RTX
switching. 5 short error tones will be emitted along with the
b
Alarm LED being illuminated. This creates a non recoverable
error and the amplifier will need to be switched off and on again.
If this problem continues you will need to contact technical
support.
22
b
will illuminate. Reduce the input
d
to reset the amplifier.
b
will illuminate. Reduce the input
d
key to reset the amplifier.
b
will be illuminate. Change the
d
b
will illuminate. To clear
b
will illuminate. Check
b
will illuminate.
button.
b
will illuminate.
button.
button to reset