Wi-Fi Protected Setup (Wps); Using Wps To Connect To A Network - Epson ET-2650 User Manual

Note: Your password must be at least 8 and no more than 22 characters long.
• Press the up and down arrow buttons to scroll through characters. Then press the right arrow
button to move to the next character.
• To switch between ABC (uppercase), abc (lowercase), or 123 (numbers and symbols), press the
home button.
• To delete characters, press the left arrow.
8. When you finish entering the new password, press the OK button.
9. To view the SSID and new password, press the OK button.
10. Press the OK button again to exit.
Parent topic:

Wi-Fi Protected Setup (WPS)

If your network uses a WPS-enabled wireless router or access point, you can quickly connect your
product to the network using Wi-Fi Protected Setup (WPS).
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access
point. If there is no hardware button, there may be a virtual WPS button in the software for the device.
Check your network product documentation for details.

Using WPS to Connect to a Network

Parent topic:
Using WPS to Connect to a Network
If you have a WPS-enabled router or access point, you can use Wi-Fi Protected Setup (WPS) to connect
your product to the network.
1. Press the WPS button on your router.
2. On the product, press the
3. Press the arrow buttons to select Wi-Fi Setup and press the OK button.
4. Press the OK button to select Wi-Fi (Recommended).
5. Press the OK button.
6. Press the arrow buttons to select Push Button Setup (WPS) and press the OK button.
Enabling Wi-Fi Direct Mode
Wi-Fi Networking
home button, if necessary.
39