Technibel CAFP 124 R Installation Instructions Manual page 10

04-393 DC INV Tech p a-44
Table 1-4 (Concealed-Duct)
Part Name
Washer
Flare insulator
Insulating tape
Drain insulator
Hose band
Packing
Drain hose
Sealing putty
Vinyl clamp
Booster cable*
* Booster cable is housed inside the electrical component box.
G
Use 3/8" for suspension bolts.
G Field supply for suspending bolts and nuts.
1-5. Tubing Size
(A) Single type
G
Refrigerant tubing between the indoor and outdoor units
shall be kept as short as possible.
G
The length of the refrigerant tubes between the indoor
and outdoor units are limited by the elevation difference
between the 2 units. During tubing work, try to make both
the tubing length (L) and the difference in elevation (H1)
as short as possible. Refer to Table 1-5.
Table 1-5
Outdoor unit type
Maximum allowable tubing length
Charge-less tubing length (actual length)
Additional charge per 1 m
12/15/04 3:04 PM Page 10
Figure
25, 36 types
Q'ty
8 For suspending indoor unit from ceiling
2 For wide and narrow tubes
2 For wide and narrow tubes flare nuts
1 For drain hose joint
1 For securing drain hose
For drain joint
1
1
1 For sealing recessed portion of power supply
8 For flare and drain insulators
1 Connector for changeover to HT tap.
Single
48 types
50 m 50 m
3 – 30 m 5 – 30 m
40g
10
Remarks
Main tubing L