Attaching the Stand (U28H750UQ*)
― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
― The exterior may differ depending on the product.
Insert the stand neck into the stand base in the
direction shown in the figure.
Hold the main body of the product with your hand
as shown by the figure. Push the assembled stand
into the main body in the direction of the arrow as
shown in the figure.
Check that the stand neck is firmly connected.
Install the COVER-REAR SUB after the power
supply and the data cable are connected.
Tightly fasten the connecting screw at the bottom
of the stand base.
Do not press down on the monitor. There is a risk
of damaging the monitor.
Place the protective Styrofoam (cushion) included
in the package on the floor and place the product
facing down on the Styrofoam, as shown in the
If Styrofoam is unavailable, use a thick sitting mat.