Example: Configuring A Physical Interface Policer For Aggregate Traffic At A - Juniper EX9200 Features Manual

Traffic Policers Feature Guide for EX9200 Switches
Related
Documentation
186
To configure a single-rate or two-rate three-color physical interface policer, include the
statement at one of the following hierarchy levels:
physical-interface-policer
[edit firewall three-color-policer
[edit logical-system logical-system-name firewall
[edit routing-instances routing-instance-name firewall
[edit logical-systems logical-system-name routing-instances routing-instance-name
firewall three-color-policer
You apply a physical interface policer to Layer 3 traffic by referencing the policer from a
stateless firewall filter term and then applying the filter to a logical interface. You cannot
apply a physical interface to Layer 3 traffic directly to the interface configuration.
To reference a single-rate two-color policer from a stateless firewall filter term, use the
nonterminating action. To reference a single-rate or two-rate three-color policer
policer
from a stateless firewall filter term, use the
The following requirements apply to a stateless firewall filter that references a physical
interface policer:
You must configure the firewall filter for a specific, supported protocol family:
ipv6 , mpls , vpls , or circuit cross-connect (
You must configure the firewall filter as a physical interface filter by including the
statement at the
physical-interface-filter
filter-name] hierarchy level.
A firewall filter that is defined as a physical interface filter can reference a physical
interface policer only.
A firewall filter that is defined as a physical interface filter cannot reference a policer
configured with the
interface-specific
You cannot configure a firewall filter as both a physical interface filter and as a logical
interface filter that also includes the
Two-Color Policer Configuration Overview on page 49
Three-Color Policer Configuration Overview on page 145
Example: Configuring a Physical Interface Policer for Aggregate Traffic at a Physical
Interface on page 187
physical-interface-filter on page 230
physical-interface-policer on page 231
policer-name]
three-color-policer
policer-name]
three-color-policer
ccc ), but not for
[edit firewall family family-name filter
statement.
interface-specific
Copyright © 2016, Juniper Networks, Inc.
policer-name]
three-color-policer policer-name]
nonterminating action.
ipv4
family any .
statement.
,