Skoda RAPID Owner's Manual page 40

Force limitation
Operational faults
Depending on the equipment configuration, the windows can be operated
electrically from the following locations: the window in the front doors or all
windows from the driver's seat. Also using the buttons for the windows in the
passenger door or the rear doors.
WARNING
The windows should be closed carefully – risk of injury!
CAUTION
In the event that the windows are frozen, first of all eliminate the ice
■
» page 79, Windows and mirrors and only then operate the electrical power
windows. Otherwise, the window sealing and the electrical power window
mechanism could be damaged.
Make sure that the windows are closed whenever you leave the locked vehi-
■
cle.
Keep the windows clean to ensure the correct functionality of the electric
■
windows.
Always close the window before disconnecting the battery.
■
For the sake of the environment
At high speeds, keep the windows closed to prevent unnecessarily high fuel
consumption.
Notice
When driving always use the existing heating, air conditioning and ventilation
system for ventilating the interior of the vehicle. If the windows are opened,
dust as well as other dirt can get into the vehicle and in addition the wind
noise is more at certain speeds.
38
Usage
39
Opening/closing the windows
40
Fig. 24 Buttons for the electric windows: variant 1/variant 2

Read and observe
The power windows operate only when ignition is switched on.
Depending on the equipment configuration, the front windows – Variant 1 or
the front and rear windows – Variant 2 can be operated with the door buttons
» fig. 24.
Buttons for the electric windows
Front door, left
A
Front door, right
B
Rear door, left
C
Rear door, right
D
Disable/enable buttons in the rear doors
E
Opening
›
Lightly press the appropriate button and hold it until the window has moved
into the desired position.
Releasing the button causes the window to stop.
For Variant 2 » fig. 24, thedriver's window can be fully opened automatically
by briefly pressing the button fully. When pressed again or after releasing the
button, the window will stop.
Closing
›
Pull gently on the top edge of the corresponding button and hold until the
window has moved into the desired position.
Releasing the button causes the window to stop.
and on page 38 first.
» fig. 24
