Some manual skills are required to change a bulb. For this reason, we recom-
mend having bulbs replaced by a specialist garage or seeking other expert help
in the event of any uncertainties.
▶
Switch off the ignition and the relevant lights before replacing a bulb.
▶
Faulty bulbs must only be replaced with the same type of bulbs. The designa-
tion is located on the light socket or the glass bulb.
A stowage compartment for replacement bulbs is located in a plastic box in
the spare wheel or underneath the floor covering in the boot.
We recommend having the headlight settings checked by a specialist garage
after replacing a bulb in the low, high or fog beam.
Defective LED diodes should be referred to a specialist.
WARNING
Always read and observe the warnings before completing any work in the
■
engine compartment
» page
86, Engine compartment.
Accidents can be caused if the road in front of the vehicle is not suffi-
■
ciently illuminated and the vehicle cannot or can only be seen with difficul-
ty by other road users.
CAUTION
Do not touch the glass bulb with your fingers (even the smallest amount of
■
dirt reduces the working life of the light bulb). Use a clean cloth, napkin, or
similar.
The protective cap of the bulb must always be properly inserted into the
■
headlight. Water and dirt may get into the headlight if the cover is not fitted
properly - there is a risk of damage to the headlight.
Notice
This Owner's Manual only describes the replacement of bulbs where it is pos-
■
sible to replace the bulbs on your own without any complications arising. Other
bulbs must be replaced by a specialist garage.
We recommend that a box of replacement bulbs always be carried in the ve-
■
hicle. Replacement bulbs can be purchased from ŠKODA Original Accessories.
114
Do-it-yourself
Replacing bulb for main beam, low beam and parking light
Fig. 99 Changing the bulb for main beam, low beam and parking light
Read and observe
and
Removing/replacing the bulb for main beam and low beam
›
Remove the protective cap
» fig.
A
›
Remove bulb
with connector in the direction of the arrow by moving it
B
side to side.
›
Remove the connector.
›
Attach the connector to the new bulb.
›
Carefully insert the bulb into the headlight with the connector.
›
Fit protective cap
.
A
Removing/replacing the bulb for the parking light
›
Remove the protective cap
» fig.
A
›
Remove the holder and bulb
C
›
Change the bulb in the socket.
›
Push the socket with the new bulb into the headlight in the opposite direc-
tion to the arrow until it stops.
›
Fit protective cap
.
A
on page 114 first.
99.
99.
» fig. 99
by moving it side to side.