Rear light
Fig. 102 Removing the light/pulling out the connector
Read and observe
and
Removing
›
Open the boot lid.
›
Lift up the cover in the direction of arrow
›
Hold the light in one hand and remove the plastic nut
arrow
with the other.
2
›
Hold the light and carefully remove it by moving it side to side.
›
Pull the connector lock
in the direction of arrow
B
›
Press the catch mechanism
C
›
Remove the connector.
Install
›
Insert the connector into the lamp and lock it securely.
›
Insert the light into the opening in the body.
›
Push in the light so that the light holder locks into the bolt on the outside of
the opening in the body.
›
Tightly screw the light with the plastic nut
row
» fig.
102.
2
›
Fold the cover in the opposite direction to arrow
116
Do-it-yourself
on page 114 first.
» fig.
102.
1
in the direction of
A
.
3
in the direction of arrow
.
4
in the opposite direction to ar-
A
.
1
CAUTION
Ensure that the cable bundle does not become pinched between the body
■
and the light when it is being refitted – risk of damage to the electrical instal-
lation and risk of water ingress.
If you are not sure whether the cable bundle has been pinched, we recom-
■
mend that you have the connection of the light checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing bulbs in tail light
Read and observe
and
›
Carefully unlock the lamp socket at the latching points marked by arrows
» fig. 102
on page 116.
›
Remove the holder from the light.
›
Remove the faulty bulb
» fig. 103
A
›
Fit a new bulb.
›
Turn the fault bulb
as far as it will go in an anti-clockwise direction and
B
remove it.
›
Install a new bulb
into the holder and turn as far as it will go in a clock-
B
wise direction.
›
Carefully fit the bulb holder in the light.
Fig. 103
Inner part of the light
on page 114 first.
from the holder.