Troubleshooting - BOMANN KS 4261 Instruction Manual

• To start the defrosting process turn the tempera-
ture control to the off state and disconnect the ap-
pliance from the power supply.
• Remove the food items and keep covered at a
cool location.
• When the ice has melted, wipe the condensate
away, empty the drip tray and dry the appliance
interior thoroughly.
• Then you may restart the appliance by connecting
the plug and turning the temperature control.
Reverse the bulb Reverse the bulb Reverse the bulb Reverse the bulb
Specification: 220- - - - 240 V Specification: 220 240 V~ ~ ~ ~ , max. 10
Specification: 220 Specification: 220 240 V 240 V
• Remove the condensate drip tray beneath the ice
compartment.
• Loosen the screw securing the ice compartment
with the thermostat housing and the screw secur-
ing the thermostat housing with the fridge wall.
• Pull the thermostat housing carefully to the front.
• Remove the light holder and change the bulb.
• Insert the light holder in correct way; reinstall the
thermostat housing as well as the ice compart-
ment.
• Insert the condensate drip tray back into its origi-
nal position.
• Reconnect the appliance and put it in operation
again.
, max. 10 W W W W
, max. 10 , max. 10

Troubleshooting

Troubleshooting
Troubleshooting Troubleshooting
Before you contact an authorized sp Before you contact an authorized specialist Before you contact an authorized sp Before you contact an authorized sp
Problem Problem Problem Problem Cause / Action Cause / Action Cause / Action Cause / Action
Appliance is - Insert the power plug correctly or
not working check the fuse.
or not - Check the temperature setting.
properly - Check the ambient temperature.
- Unblock the ventilation openings,
install the appliance freely.
Stored food - Check the temperature setting.
is too warm - Open the door only as long as neces-
sary.
- Check the location.
Loud noise - Check the appliance position.
during oper- - See the section "Operating noise".
ation
Water on the Check the temperature setting.
appliance
bottom
Interior light - Insert the power plug correctly or
is not work- check the fuse.
ing - See the section "Reverse the bulb".
Water on the On days of high humidity, condensation
outer sur- might occur on the outer surface of the
face. appliance. No malfunction!
NOTE: NOTE:
NOTE: NOTE:
If a problem still persists after following the steps
above, contact your trader or an authorized techni-
cian.
19
ecialist ecialist ecialist