Replacing The Gator® Speedload™ (Gsl) - Oregon ST275 GSL Original Instruction Manual

Replacing the Gator® Speedload™
(GSL)
The trimmer/edger is equipped with the
innovative GSL Cutting System The GSL head
contains a disk of trimmer line that is pre-
wound and self-contained The GSL disk lasts
longer than typical trimmer line Removing and
replacing a disk is simple
• Pull the head off the base Pull out the spent
disk and discard it (Fig 21)
FIG. 21
• Peel two separate pieces of trimmer line from
opposite sides of the disk Make sure each
piece is pulled away to create a small gap
between the peeled trimmer lines and the disk
(Fig 22)
FIG. 22
Trimmer/Edger Model ST275-GSL
Maintenance and Cleaning
• Place the disk inside the head by lining the
disk's centre hole with the hole in the centre
of the head Press the disk firmly into place
(Fig 23)
FIG. 23
• Make sure the ends of the trimmer line pieces
fit through the two sets of pegs in the head
(Fig 24)
FIG. 24
• Place GSL head back onto the base and press
firmly until it clicks into place
The innovative tongue-and-groove disk
eliminates the need for threading of trimmer
line Disks last longer than traditional trimming
lines
23