Advertisement
3. INSTALLATION WORK
3.1. Front panel, control box cover removal
(1) Open the intake grille. While gently pressing the left and
right mounting shafts of the intake grille outward "a",
remove the intake grille in direction of the arrow "b".
Intake grill removal
(2) Remove 4 caps.
(3) Remove wire cover screw, then remove the wire cover.
(4) Remove 10 screws.
Wire cover screw
Caps (4 places)
3.2. Installing the terminal block
(1) Attach the terminal block to the indoor unit firmly with 1 screw (M4x25, accessory).
(2) Place the wiring as per the figure.
Place the wires from the terminal
block under the other wires.
(Front view)
Screw (M4x25)
(accessory)
Terminal block (with wire)
En-2
a
b
Wire cover
Screws
(10 places)
(5) Pull the front panel forward raising the upper surface, to
remove the front panel.
(6) Remove 2 screws, then remove the control box cover.
Screw
Screw
Indoor unit main PCB
Control box
cover
(Rightside view)
Place wire under the tab.
Front
panel
Advertisement
