Storage for 300 series and 500 series ProLiant
storage servers
The 300 series and 500 series storage servers ship pre-configured for the
Operating System only. Additional storage configuration is needed.
Depending on the type of storage server purchased, storage
configuration may involve local storage configuration via the HP Array
Configuration Utility or SAN management tools.
Physical drive configuration
Each 300 series and 500 series storage server comes with two
hot-pluggable hard drives for the Operating System only. The drives are
configured by default into two logical disks at the Smart Array controller
level as follows:
Table 15
Logical disk
1
2
Primary Operating System Disk 0
Primary Operating System Disk
Physical Disk 0
Figure 13
NOTE:
and 2. In Disk Manager, logical disks are displayed as 0 and 1.
Data volumes are not carved at the factory nor by the Quick Restore
DVD, and must be configured manually by the end user. Refer to the HP
ProLiant Storage Server Administration Guide for additional information.
44
Server Storage
Hard drive configuration
RAID
RAID 1
RAID 1
Logical Disk 1
RAID 1
Logical Disk 2
Disk 1
Physical Disk 1
Hardware RAID
In the HP Array Configuration Utility, logical disks are labeled 1
Size/allocation
27 GB across physical drive 0, 1
7 GB across physical drive 0, 1
15161A