Apm Configuration; Network Stack Configuration; Hdd/Ssd Smart Information; Usb Configuration - Asus STRIX B250I GAMING User Manual

Intel LAN Controller [Enabled]
[Enabled]
[Disabled]
3.6.8

APM Configuration

ErP Ready [Disabled]
Allows BIOS to switch off some power at S5 to get the system ready for ErP requirement.
When set to [Enabled], all other PME options will be switched off.
Configuration options: [Enable(S4+S5)] [Enable(S5)] [Disabled]
3.6.9

Network Stack Configuration

The items in this menu allow you to configure Ipv4 / Ipv6 PXE support.
3.6.10

HDD/SSD SMART Information

This menu displays the SMART information of the connected devices.
3.6.11

USB Configuration

The items in this menu allow you to change the USB-related features.
The USB Devices item shows the auto-detected values. If no USB device is detected, the
item shows None.
USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to section 1.1.2 Motherboard layout for the location of the USB ports.
3.7

Monitor menu

The Monitor menu displays the system temperature/power status, and allows you to change
the fan settings.
Q-Fan Configuration
The subitems in this menu allow you to configure the Q-Fan features.
Qfan Tuning
Click this item to automatically detect the lowest speed and configure the minimum duty cycle
for each fan.
3-14
Enables the Intel LAN controller.
®
Disables the controller.
Chapter 3: BIOS Setup