Advertisement
Step 7
BI20
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the right side of the
building. Each screw and bolt in the
roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square.
This will make the roof panels t
better, and holes will align.
1
Locate the roof panels by their
numbers and place them on the
ground alongside the building in their
proper positions.
2
Position a right roof panel at the
right side and fasten to the gable and
header using screws and bolts as
shown. Do not fasten the lower end
of the panels to the rear wall angle
until both panels are in place.
Note: Tab of roof beam is fastened
between roof panel and gable using
the center hole.
3
Install the left roof panel on the
left side in the position shown above.
Fasten at overlap with a bolt.
4
Fasten the lower end of the panels
to the rear wall angle using screws.
Parts Needed For
Roof Assembly
STEP
3
STEP
1
7465 Left Roof Panel
20
7464 Right Roof Panel (1)
7465 Left Roof Panel (1)
STEP
2
Nut
Washer
Bolt
STEP
4
7464 Right Roof Panel
Advertisement
