Safety Instructions - Ryobi BCS618 User Manual

GB
FR DE ES

SAFETY INSTRUCTIONS

This appliance is not intended for use by persons
(including children) with reduced understanding, or lack
of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Do not
let children play with this appliance.
CAUTION
When using the battery charger, the following
basic safety precautions should be observed for
protection against electric shock, danger of injury
and burns.
Please read and observe these instructions before using
the device.
„ Before using the device check that the mains cable
and mains plug are not damaged.
„ The device must not be damp, neither should it be
used in a damp environment.
„ Do not use the device if it has suffered any heavy
shock or jolting, or is damaged in any other way.
„ Due to the heat generated during charging, the battery
charger should not be operated on a combustible
surface or in an inflammable environment
„ Do not cover the ventilating slits
„ Never disassemble the device yourself. Danger of
an electric shock or fire could be caused by improper
reassembly.
„ Pull the plug of the battery charger out of the socket
when it is not in use or when cleaning it.
„ Only use extension cable that is approved and
technically in perfect condition.
„ During operation provide sufficient ventilation.
Malfunction during charging can be caused by storing
and operating in places where the temperature
exceeds +40°C; this should be avoided. Battery
charging in closed cupboards, near heat sources
(radiators, bright sunshine) etc. causes heat to
accumulate and can damage the device.
„ If the battery is not going to be used for a long period,
pull the battery off the battery charger and pull out the
mains plug.
„ Protect battery contacts from metallic objects to avoid
a short circuit which could result in a fire or explosion!
„ Do not rivet or screw any name-plates or signs onto
the device. The protective insulation can thereby
be rendered ineffective. Adhesive labels are
recommended.
„ Only charge original recommended batteries.
IT NL PT DK SE FI NO RU PL CZ
English
„ If the power cord is damaged, it must be replaced by an
Authorised Service Center in order to avoid a hazard.
WARNING
D o n o t r e c h a r g e p r i m a r y c e l l s ( n o n -
rechargeable).
Damage to property/material
Mains voltage must correspond with the voltage
specifications on the device.
ASSEMBLY
ASSEMBLING WALL MOUNT BRACKET
See Fig. 2 - 3
„ Find desired location indoors and away from any
objects that could block vents on charger. Locate a
wall stud to securely mount bracket.
„ You will need two #8 -63.5mm screws (not included)
„ Use a level to be sure that bracket is in a vertical
position.Use a pencil to mark screw hole placement.
Screws should be installed so that the center distance
is 381mm.
„ Install screws to securely attach bracket.
„ Place bottom end of charger into bracket then snap
top of charger securely into bracket.
„ Charger should fit snugly and securely in bracket.
DESCRIPTION (See Figures 1-3)
1. BCS618 Charger
2. Battery Port
3. Blue LED status button
4. Battery Port LEDs
5. Bumper
6. Carry handle
7. Mount backet
8. "Key hole" hanger
9. Screwdriver
10. Screws
11. Pencil
12. Green LED
13. Red LED
14. Charger indicator label
1
HU RO LV LT EE HR SI SK GR TR