Advertisement
SAFETY INSTRUCTIONS
CAUTION
When using the battery charger, the following
basic safety precautions should be observed for
protection against electric shock, danger of injury
and burns.
Please read and observe these instructions
before using the device.
Before using the device, check that the mains cable
and mains plug are not damaged.
The device must not be damp, neither should it be
used in a damp environment.
Do not use the device if it has suffered any heavy
shock or jolting, or is damaged in any other way.
Due to the heat generated during charging, the battery
charger should not be operated on a combustible
surface or in an inflammable environment.
Do not cover the ventilating slits.
Never disassemble the device yourself. Danger of
electric shock or fire could be caused by improper
reassembly.
Pull the plug of the battery charger out of the socket
when it is not in use or when cleaning.
Only use an extension cable that is approved and
technically in perfect condition.
During
operation,
Malfunction during charging can be caused by storing
and operating in places where the temperature
exceeds +40°C; this should be avoided. Battery
charging in closed cupboards, near heat sources
(radiators, bright sunshine) causes heat to accumulate
and can damage the device.
If the battery is not going to be used for a long period,
pull the battery off the battery charger and pull out the
mains plug.
Protect battery contacts from metallic objects to avoid
short circuit which could result in fire or explosion!
Do not rivet or screw any name-plates or signs
onto the device. The protective insulation can
thereby be rendered ineffective. Adhesive labels are
recommended.
Only charge original recommended batteries.
provide
sufficient
ventilation.
English
If the power cord is damaged, it must be replaced by
an Authorised Service Center in order to avoid hazard.
WARNING
D o n o t r e c h a r g e p r i m a r y c e l l s ( n o n -
rechargeable).
Damage to property/material
Mains voltage must correspond with the voltage
specifications on the device.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with the
appliance.
This appliance is not intended for use by young
children or infirm persons unless they have been
adequately supervised by a responsible person to
ensure that they do not play with the appliance.
Keep children and visitors away. Visitors should
wear safety glasses and be kept at a safe distance
from the work area. Do not let visitors contact the tool
or the extension cord.
Complies with AS/NZS 60335.
ASSEMBLY
ASSEMBLING WALL MOUNT BRACKET
See Fig. 2 - 3
Find desired location indoors and away from any
objects that could block vents on the charger. Locate a
wall stud to securely mount the bracket.
You will need two #8 - 63.5mm screws (not included).
Use a level to be sure that bracket is in a vertical
position. Use a pencil to mark the screw hole
placement. Screws should be installed so that the
center distance is 381mm.
Install screws to securely attach bracket.
Place bottom end of charger into the bracket, then
snap the top of charger securely into the bracket.
Charger should fit snugly and securely in the bracket.
1
Advertisement
