Huawei S Series White Paper page 65

S Series Switches
iStack Technology White Paper

Step 6 Check that stack cables are correctly connected.
If the switch uses service ports and stack ports, check the configuration of the stack ports.
Run the display stack port [ configuration ] [ slot slot-id ] command to check the
configuration of stack ports.
Compare the ports displayed in the command output with the ports used for stack connection.
<HUAWEI> display stack port
*down : administratively down
Logic Port
----------------------------------------------------------------------------
Issue 01 (2013-05-25)
BoardType=
BarCode=
Item=
Description=
Manufactured=
VendorName=
IssueNumber=
CLEICode=
BOM=
If fields under [Board Properties] are not empty, go to step 6.
<HUAWEI> display elabel slot 0 2
/$[System Integration Version]
/$SystemIntegrationVersion=3.0
[Slot_0]
/$[Board Integration Version]
/$BoardIntegrationVersion=3.0
[Main_Board]
/$[ArchivesInfo Version]
/$ArchivesInfoVersion=3.0
[Board Properties]
BoardType=CX22ETPC
BarCode=210235000c0120081008
Item=0235000c
Description=CX22ETPC for S5700 HindCard
Manufactured=2008-11-14
VendorName=Huawei
IssueNumber=
CLEICode=
BOM=
NOTE
Perform this step only on switches that set up a stack using service interfaces.
Phy Port
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Online Status
5 Troubleshooting
61