Table of Contents
Advertisement
S Series Switches
iStack Technology White Paper
Step 2 Configure stack interfaces.
# On SwitchA, configure XGigabitEthernet0/0/1 and GigabitEthernet0/0/2 as physical
member interfaces and add them to stack port 0/1 and stack port 0/2 respectively.
<HUAWEI> system-view
[HUAWEI] sysname SwitchA
[SwitchA] interface stack-port 0/1
[SwitchA-stack-port0/1] port interface XGigabitEthernet 0/0/1 enable
Warning: Enabling stack port cause configuration loss on the interface, continue?[Y/N]:y
Info: This operation may take a few seconds. Please wait for a moment.......
Info: Ports XGigabitEthernet0/0/1 to XGigabitEthernet0/0/4 have been configured as
physical stack-port.
[SwitchA-stack-port0/1] quit
[SwitchA] interface stack-port 0/2
[SwitchA-stack-port0/2] port interface XGigabitEthernet 0/0/2 enable
Warning: Enabling stack port cause configuration loss on the interface, continue?[Y/N]:y
Info: This operation may take a few seconds. Please wait for a moment.......
Info: Ports XGigabitEthernet0/0/1 to XGigabitEthernet0/0/4 have been configured as
physical stack-port.
[SwitchA-stack-port0/2] quit
# On SwitchB, configure XGigabitEthernet0/0/1 and GigabitEthernet0/0/2 as physical
member interfaces and add them to stack port 0/1 and stack port 0/2 respectively.
<SwitchB> system-view
[SwitchB] interface stack-port 0/1
[SwitchB-stack-port0/1] port interface XGigabitEthernet 0/0/1 enable
Warning: Enabling stack port cause configuration loss on the interface, continue?[Y/N]:y
Info: This operation may take a few seconds. Please wait for a moment.......
Info: Ports XGigabitEthernet0/0/1 to XGigabitEthernet0/0/4 have been configured as
physical stack-port.
[SwitchB-stack-port0/1] quit
[SwitchB] interface stack-port 0/2
[SwitchB-stack-port0/2] port interface XGigabitEthernet 0/0/2 enable
Warning: Enabling stack port cause configuration loss on the interface, continue?[Y/N]:y
Info: This operation may take a few seconds. Please wait for a moment.......
Info: Ports XGigabitEthernet0/0/1 to XGigabitEthernet0/0/4 have been configured as
physical stack-port.
[SwitchB-stack-port0/2] quit
Step 3 Power cycle the switches and connect the switches through stack cables.
Step 4 View the stack configuration.
<SwitchA> display stack
Stack topology type: Ring
Stack system MAC: 80fb-06af-7570
MAC switch delay time: 10 min
Stack reserve vlan : 4093
Slot of the active management port: --
slot
Issue 01 (2013-05-25)
NOTE
Power off SwitchA and SwitchB, connect the two switches through stack cables, and then power on
SwitchA and SwitchB in sequence.
Stack port 0/1 of the local device must be connected to stack port 0/2 of the remote device. Otherwise,
the two devices cannot set up a stack.
Role
Mac address
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Priority
Device type
4 Application Scenarios
48
Advertisement
Table of Contents
