Kyocera FS-C1020MFP Plus Service Manual page 127

System Maintenance Reference
Init Engine
EEPROM
Model
Brand ID
Maintenance ID
Adjusts the horizontal registration for the bypass
Horiz Bypass tray. If the machine settings are reset to the factory
Tray defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Adjusts the vertical registration for the bypass tray.
Vert Bypass If the machine settings are reset to the factory
Tray defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Adjusts the horizontal registration for the back side
in duplex mode. If the machine settings are reset
Horiz.Dup Back
to the factory defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Adjusts the vertical registration for the back side in
duplex mode. If the machine settings are reset to
Vert.Dup Back
the factory defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
This clears all counters except "Full Color" and "Black and White" in
the total counter.
When you execute "Init Engine EEPROM", the engine EEPROM is
initialized.
Turn the machine power off/on after you change this setting.
Displays only
Displays the current model.
Do not change this setting (Designed for Factory Use).
00* – 7F
Displays the current brand ID number.
Do not change this setting (Designed for Factory Use).
00* – 7F
Displays the current maintenance ID number.
Do not change this setting (Designed for Factory Use).
117