Mazda 3 Owner's Manual page 569

11. Insert the air compressor plug into the
accessory socket inside the vehicle and
switch the ignition to ACC.
Refer to Accessory Sockets on page
5-155 .
Compressor plug
Centre console
CAUTION
When inserting the air compressor
plug into or removing it from the
accessory socket, make sure that the air
compressor switch is OFF. When turning
the air compressor ON/OFF, use the air
compressor switch.
12. The sealant is injected into the tyre
when the air compressor is switched
ON. After the sealant is injected
completely, wait until the tyre infl ation
pressure increases to the specifi ed tyre
infl ation pressure.
NOTE
The infl ation pressure may increase
to about 300 kPa (3.1 kgf/cm
43.5 psi) temporarily to inject the
sealant through the valve. Normally, the
infl ation pressure decreases gradually
and it reaches the actual infl ation
pressure after about 30 seconds.
Compressor
2
, 3 bar,
WARNING
Never use the air compressor above 300
2
kPa (3.1 kgf/cm , 3 bar, 43.5 psi):
Using the air compressor at an
infl ation pressure above 300 kPa (3.1
2
kgf/cm , 3 bar, 43.5 psi) continuously
is dangerous. If the air compressor
overheats, hot air will be exhausted and
you could get burned.
CAUTION
If the air compressor operates slowly or
becomes hot, this indicates overheating.
Turn the air compressor OFF
immediately and cancel the procedure.
In this case, leave the air compressor
turned OFF for about 30 minutes or
longer and wait until the temperature
decreases.
If Trouble Arises
Flat Tyre
7–11