Start-Up Checklist - Howe 1000-RLE Installation & Service Manual

Start‐Up Checklist
1. Is the operating water level in the Water Sump correct?
(see Float Valve p.14)
2. Is the operating water level in the Water Distribution Pan correct?
(see Water Distribution Pan p.14)
3. Is the Stop Valve on Sump Drain connection closed?
(see Stop Valve p.14)
4. Is the Suction Temperature at the Evaporator correct?
(see Evaporator Pressure Setting p.17)
5. Have you visually inspected the freezing surface of the Evaporator?
(see Adjusting Refrigeration to the Ice Flaker p.18)
6. Have you set the Fan Cycling Control (1000‐RLE & 2000‐RLE only)?
(see Fan Cycling Control p.19)
7. Have you set the Low Pressure Control on the Condensing Unit?
(see Low Pressure Control p.19)
8. Have you run a Field Capacity Check?
(see Field Capacity Check p.20)
9. Have you set the Off‐Delay Setting on the Control Module?
(see Off‐Delay Setting p.22)
10. Have you set the Motor Overload Setting on the Control Module?
(see Motor Overload Setting p.23)
11. Have you verified proper Sequence of Operation by the Photo Eye sensors?
(see Sequence of Operation p.25)
12. Have you verified proper rotation by the Gear Motor or Drive Motor?
(see Gear Motor (1000‐RLE) p.28)
(see Drive Motor and Speed Reducer (2000‐RLE & 3000‐RLE) p.29)
13. Have you completed and returned the Ice Flaker warranty registration?
30