Power Supply - Philips AZ5130 Expanium Manual

IMPORTANT!
For best CD/MP3-CD/VCD playback, please plug in your set to an AC power supply where
convenient.
If operated in DC mode, see below approximate playtime. (Playtime is also varied from
different brand batteries) :
The CD part of this system also serves as a Video CD player if you connect it to your TV
set.
Before viewing the Video CD, ensure that the set is switched to corresponding PAL or
NTSC system of your TV set (exception Multi-system TV).
BATTERIES (NOT SUPPLIED)
Whenever convenient, use the mains supply if you want to conserve battery life. The battery supply
will be switched off when the set is connected to the mains. Make sure you remove the plug from the
set and wall outlet before inserting batteries.
Batteries
1. Open the battery compartment and insert six batteries, type
R14, UM2 or C-cells, (preferably alkaline) with the correct
polarity as indicated by the "
compartment.
Remote control
Open the battery compartment and insert two batteries,
type AAA, R03 or UM4 (preferably alkaline).
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place.
3. Remove the batteries if they are exhausted or if they will not be
used for a long period.
– The incorrect use of batteries can cause electrolyte leakage and
will corrode the compartment or cause the batteries to burst. Therefore:
– Do not mix battery types, e.g. alkaline with zinc carbonate.
– When inserting new batteries, replace all at the same time.
– Remove the batteries if the set is not to be used for a long time.
Notes :
– The battery supply is switched off when the set is connected to the mains.
TV screen is disabled during CD / MP3-CD playing if your AZ5130 is battery
powered.
Batteries contain chemical substances, so they should be disposed of properly
Battery type
Alkaline
Zinc Cartonate
+ -
" and " " symbols inside the

POWER SUPPLY

Playtime
approximate 9 hrs
approximate 45 minutes
6 x 1.5V R14/ UM2/ C CELL
9