Docking Station Placement; De | Deutsch - Bosch INDEGO 400 CONNECT Installation Manual

Docking station placement

2
Determine the best place to position your docking station,
where your Indego will return on its own to get charged.
2.1
Separate the mower from the docking station.
Place the docking station
on level ground.
This will allow your Indego to dock correctly.
Place the docking station
2.2
beside the cutting area
with a straight 1.5 m track in front
of the docking station.
It is recommended to place it as close to a
corner and at once also to the next power
supply as possible.
Additionally leave 1.0 m of free space
perpendicular to the docking station
as shown in the picture. This will
enable your Indego to return
to the docking station correctly
in clockwise direction.
10
1.0 m
30 cm
1.5 m
30 cm
!
2.3 The docking station for your Indego should be placed
at the side of the lawn.
Whilst stood in the grass area to be
cut it is important that the docking
station charging pins point left
(so you can read the Bosch logo whilst standing
outside the lawn area).
If the docking station is positioned with the charging pins
pointing either into the grass area or pointing to the right
your Indego will not run.
Make sure the docking station
2.4
is placed where possible out of
direct sunlight.
When your Indego receives direct sunlight for a pro-
longed period of time the battery can get too hot and
not function correctly.
Place the docking station close
2.5
to a power socket.
Total length of the power cable is 5 m plus 2 m from
the power supply to the plug.
Fix the 4 docking station screws
2.6
30 cm
in place with the hex key.
They come together as a 5 piece set so you will need
to separate them first.
GB
max.
45 °C
11